Setting up a Brick Paver Walkway or Building Brick Wall

The use of Bricks or Pavers to create a sidewalk or patio area complements a home in a method that is unrivaled. In addition, installing a Brick or Paver walkway does not necessarily need a pro.

The secret to setting up a Brick or Paver Walkway is to first correctly prepare the area where the bricks/pavers are to be installed. In addition, string lines need to be strung on each side of the sidewalk.
As soon as the location has been dug down, 3/4" gravel stone need to be laid in and tamped down tightly. The height between the tamped down sand and the stringline need to equate to the density of the brick or paver.

Now that you have a stable base, put a 1" pipeline or journal board the length of the walkway on either side of the sidewalk. Using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your pathway border and aid to maintain the integrity and shape of the pathway. You can get these plastic strip borders at a lot of house enhancement stores. The strips must be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

Once this is done, you can then start to lay the bricks/pavers. There are lots of patterns you can lay. I particularly like the Herring Bone pattern. The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again assist keep the integrity of the pathway.

Undoubtedly bricks/pavers will need to be cut or divided when building the pathway. To in fact cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you want to break the brick. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, construct up the outside edges with additional sand, and then shovel in the topsoil and load down securely.
Spread stone dust over the new pathway and sweep into the cracks. Repeat this procedure a number of times to make sure the fractures are fully filled. This will finish the interlocking of the bricks and help to remove any weed growth. Just include grass seed to the outside edges more info and you ought to have a lovely entryway to your home within a read more couple of weeks.


In addition, installing a Brick or Paver pathway does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be set up. Now that you have a stable base, put a 1" pipeline or journal board the length of the walkway on either side of the pathway. These strips will act as your walkway border and assistance to preserve the stability and shape of the sidewalk. Undoubtedly bricks/pavers will require to be cut or divided when building the sidewalk.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Setting up a Brick Paver Walkway or Building Brick Wall”

Leave a Reply

Gravatar